Search results
Results from the WOW.Com Content Network
A template for displaying common fractions of the form int+num/den nicely. It supports 0–3 anonymous parameters with positional meaning. Template parameters [Edit template data] Parameter Description Type Status leftmost part 1 Denominator if only parameter supplied. Numerator if 2 parameters supplied. Integer if 3 parameters supplied. If no parameter is specified the template will render a ...
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.
A template for displaying common fractions of the form int+num/den nicely. It supports 0–3 anonymous parameters with positional meaning. Template parameters [Edit template data] Parameter Description Type Status leftmost part 1 Denominator if only parameter supplied. Numerator if 2 parameters supplied. Integer if 3 parameters supplied. If no parameter is specified the template will render a ...
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
Any such symbol can be called a decimal mark, decimal marker, or decimal sign. Symbol-specific names are also used; decimal point and decimal comma refer to a dot (either baseline or middle ) and comma respectively, when it is used as a decimal separator; these are the usual terms used in English, [ 1 ] [ 2 ] [ 3 ] with the aforementioned ...
A handy chart of decimal-fraction equivalents, 0 to 1 by 64ths. Prints nicely as 11x17 in landscape orientation. Useful for machinists who work with inch-based measurements. Date: 24 October 2007: Source: Own work: Author: Three-quarter-ten
So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths). (Decimal places for .25, .5, and .75 are shown to thousandths [.250, .500, .750], which is how machinists usually think ...
The template is intended for conversion of heights specified in either metres or in feet and inches. Template parameters [Edit template data] Parameter Description Type Status Metres m metre metres meter meters The height in metres. Do not use if feet and inches are specified. Number optional Centimetres cm centimetre centimetres centimeter centimeters The height in centimetres. Do not use if ...