Search results
Results from the WOW.Com Content Network
A forwarding information base (FIB), also known as a forwarding table or MAC table, is most commonly used in network bridging, routing, and similar functions to find the proper output network interface controller to which the input interface should forward a packet.
The Maharashtra State Board of Secondary and Higher Secondary Education (Abbreviation: MSBSHSE) is a statutory and autonomous body established under the "Maharashtra Secondary Boards Act" 1965 (amended in 1977). [1] Most important task of the board, among few others, is to conduct the SSC for 10th class and HSC for 12th class examinations. [2]
The bridge has three ports. A is connected to bridge port 1, B is connected to bridge port 2, C is connected to bridge port 3. A sends a frame addressed to B to the bridge. The bridge examines the source address of the frame and creates an address and port number entry for host A in its forwarding table. The bridge examines the destination ...
Switching loops can cause misleading entries in a switch's media access control (MAC) database and can cause endless unicast frames to be broadcast throughout the network. A loop can make a switch receive the same broadcast frames on two different ports, and alternatingly associate the sending MAC address with the one or the other port.
Cisco IOS is a monolithic operating system running directly on the hardware while IOS XE is a combination of a Linux kernel and a monolithic application (IOSd) that runs on top of this kernel. On the other hand, IOS XR is based on QNX (since version 5.0 it's also based on Linux), where the IOSd application has been separated into many different ...
Different terms have been used to market products based on data center bridging standards: Data Center Ethernet (DCE) was a term trademarked by Brocade Communications Systems in 2007 but abandoned by request in 2008. [3]
In contrast to an Ethernet hub, there is a separate collision domain on each switch port. This allows computers to have dedicated bandwidth on point-to-point connections to the network and also to run in full-duplex mode. Full-duplex mode has only one transmitter and one receiver per collision domain, making collisions impossible.
For example, on Cisco routers, routes issued by the Open Shortest Path First routing protocol have a lower default administrative distance than routes issued by the Routing Information Protocol. This is because, by default on Cisco routers, OSPF has a default administrative distance of 110 and RIP has a default administrative distance of 120.