Search results
Results from the WOW.Com Content Network
Ramset powder-actuated tool. A powder-actuated tool (PAT, often generically called a Hilti gun or a Ramset gun after their manufacturing companies) is a type of nail gun used in construction and manufacturing to join materials to hard substrates such as steel and concrete.
ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter.
Studs with a length of engagement equal to about 1 d: Active: DIN 939: Studs with a length of engagement equal to about 1,25 d: Active: DIN 946: Determination of coefficient of friction of bolt/nut assemblies under specified conditions: Withdrawn: DIN EN ISO 16047: ISO 16047: DIN 960: M8x1 to M100x4 hexagon head bolts with fine pitch thread ...
In 1941, the Hilti company Maschinenbau Hilti OHG was founded by Martin (1915–1997) and Eugen Hilti (1911–1964), [3] with the opening of a mechanical workshop in Schaan, Liechtenstein. Martin Hilti was trained in mechanical engineering and automotive design at the Wismar Engineering College and was 26 at the time of founding the company.
An ASME B18.2.1 compliant cap screw has somewhat tighter tolerances than a hex bolt for the head height and the shank length. The nature of the tolerance difference allows an ASME B18.2.1 hex cap screw to always fit where a hex bolt is installed but a hex bolt could be slightly too large to be used where a hex cap screw is designed in.
Self-tapping screws have a wide range of tip and thread patterns, and are available with almost any possible screw head design. Common features are the screw thread covering the whole length of the screw from tip to head and a pronounced thread hard enough for the intended substrate, often case-hardened. [1]
Even though #14 and #16 screws are still available, they are not as common as sizes #0 through #12. [citation needed] Sometimes "special" diameter and pitch combinations (UNS) are used, for example a 0.619 in (15.7 mm) major diameter with 20 threads per inch. UNS threads are rarely used for bolts, but rather on nuts, tapped holes, and threaded ODs.
A cast-in-place anchor bolt. The simplest – and strongest – form of anchor bolt is cast-in-place, with its embedded end consisting of a standard hexagonal head bolt and washer, 90-bend, or some sort of forged or welded flange (see also stud welding). The last are used in concrete-steel composite structures as shear connectors. [6]