Search results
Results from the WOW.Com Content Network
For an NPN open emitter output, the collector is connected to the positive voltage rail, so the emitter outputs a high voltage when the transistor is on and is hi-Z when off. For a PNP open emitter output, the collector is connected to the low voltage supply, so the emitter outputs a low voltage when the transistor is on and is hi-Z when off.
Open-emitter buffers connected as wired OR. See also: Diode logic § Active-high OR logic gate. The wired OR connection electrically performs the Boolean logic operation of an OR gate using open emitter or similar inputs (which can be identified by the ⎏ symbol in schematics) connected to a shared output with a pull-down resistor. This gate ...
The transistor continuously monitors V diff and adjusts its emitter voltage to equal V in minus the mostly constant V BE (approximately one diode forward voltage drop) by passing the collector current through the emitter resistor R E. As a result, the output voltage follows the input voltage variations from V BE up to V +; hence the name ...
Isuzu Elf box truck. A box truck—also known as a box van, cube van, bob truck [1] or cube truck—is a chassis cab truck with an enclosed cuboid-shaped cargo area. [2] On most box trucks, the cabin is separate to the cargo area; however some box trucks have a door between the cabin and the cargo area, box trucks tend to be larger than cargo vans and smaller than tractor-trailers with movable ...
In electronics, emitter-coupled logic (ECL) is a high-speed integrated circuit bipolar transistor logic family. ECL uses an overdriven bipolar junction transistor (BJT) differential amplifier with single-ended input and limited emitter current to avoid the saturated (fully on) region of operation and the resulting slow turn-off behavior. [2]
⎐ - open collector or open drain pin that outputs a low voltage when on or hi-Z when off. I think the opposite would be correct: ⎐ - open collector or open drain pin that outputs a low voltage when off or hi-Z when on. In other words: The output has low impedance when the input is low and high impedance when the input is high.
The collector–emitter current can be viewed as being controlled by the base–emitter current (current control), or by the base–emitter voltage (voltage control). These views are related by the current–voltage relation of the base–emitter junction, which is the usual exponential current–voltage curve of a p–n junction (diode).
In this circuit the emitter terminal of the transistor serves as the input, the collector as the output, and the base is connected to ground, or "common", hence its name. The analogous field-effect transistor circuit is the common-gate amplifier.