Search results
Results from the WOW.Com Content Network
Collects steam at the top of the boiler (well above the water level) so that it can be fed to the engine via the main steam pipe, or dry pipe, and the regulator/throttle valve. [2] [5] [6]: 211–212 [3]: 26 Air pump / Air compressor Westinghouse pump (US+) Powered by steam, it compresses air for operating the train air brake system. [3]: 2 The ...
A compound steam engine unit is a type of steam engine where steam is expanded in two or more stages. [ 1 ] [ 2 ] A typical arrangement for a compound engine is that the steam is first expanded in a high-pressure (HP) cylinder , then having given up heat and losing pressure, it exhausts directly into one or more larger-volume low-pressure (LP ...
The higher cost of turbines and the associated gears or generator/motor sets is offset by lower maintenance requirements and the smaller size of a turbine in comparison with a reciprocating engine of equal power, although the fuel costs are higher than those of a diesel engine because steam turbines have lower thermal efficiency. To reduce fuel ...
Diagram of a typical gas turbine jet engine. Air is compressed by the compressor blades as it enters the engine, and it is mixed and burned with fuel in the combustion section. The hot exhaust gases provide forward thrust and turn the turbines which drive the compressor blades. 1. Intake 2. Low pressure compression 3. High pressure compression ...
In all turbines the blade velocity is directly proportional to the velocity of the steam passing over the blade. Now, if the entire energy of the steam is extracted in one stage, i.e. if the steam is expanded from the boiler pressure to the condenser pressure in a single stage, then its velocity will be very high.
On a ship, the engine room (ER) [1] is the compartment where the machinery for marine propulsion is located. The engine room is generally the largest physical compartment of the machinery space. It houses the vessel's prime mover, usually some variations of a heat engine (steam engine, diesel engine, gas or steam turbine). On some ships, there ...
The basic configuration was described as a 2-on-1 design, meaning that two gas turbines produced steam to feed one steam turbine. Supplemental firing was utilized to increase steam production so as to fill the 100 MW single-case steam turbine. In the initial design, approximately 20% of the fuel input was fired in the duct burner.
Until the development of compound engines, steam engines used the steam only once before it was recycled back to the boiler. A compound engine first recycles the steam into one or more larger, lower-pressure secondary cylinders, to use more of its heat energy. Compound engines could be configured to increase either a ship's economy or its speed.