Search results
Results from the WOW.Com Content Network
This stops regenerative latching process and results in a fast turn-off. Both the MOSFET connected to the cathode and MOSFET connected to the gate of the thyristor is not subjected to high-voltage stresses irrespective of the magnitude of the voltage on the ETO, due to the internal structure of the thyristor containing a P-N junction. The ...
Many SSRs use optical coupling. The control voltage energizes an internal LED which illuminates and switches on a photo-sensitive diode (photo-voltaic); the diode current turns on a back-to-back thyristor , SCR, or MOSFET to switch the load. The optical coupling allows the control circuit to be electrically isolated from the load.
Separable assembly or sub-assembly (e.g. printed circuit assembly) AT: Attenuator or isolator: BR: Bridge rectifier (four diodes in a package) often changed to "D" for diode BT, BAT: Battery or battery holder: often shortened to "B" C: Capacitor: CB: Circuit breaker: CN: Capacitor network: may be simplified to "C" for capacitor D, CR: Diode ...
In most circuits, this means pulling an enhancement-mode MOSFET's gate voltage towards its drain voltage turns it on. In a depletion-mode MOSFET, the device is normally on at zero gate–source voltage. Such devices are used as load "resistors" in logic circuits (in depletion-load NMOS logic, for example).
A thyristor with only one MOSFET in its equivalent circuit, which can only be turned on (like normal SCRs), is called an MOS-gated thyristor. Schematic of a MOSFET-controlled thyristor Positive voltage on the gate terminal with respect to the cathode turns the thyristor to the on state.
NTC thermistors can be used as inrush-current limiting devices in power supply circuits when added in series with the circuit being protected. They present a higher resistance initially, which prevents large currents from flowing at turn-on. As current continues to flow, NTC thermistors heat up, allowing higher current flow during normal operation.
An N-MOSFET/IGBT needs a significantly positive charge (V GS > V th) applied to the gate in order to turn on. Using only N-channel MOSFET/IGBT devices is a common cost reduction method due largely to die size reduction (there are other benefits as well). However, using nMOS devices in place of pMOS devices means that a voltage higher than the ...
Overdrive voltage, usually abbreviated as V OV, is typically referred to in the context of MOSFET transistors.The overdrive voltage is defined as the voltage between transistor gate and source (V GS) in excess of the threshold voltage (V TH) where V TH is defined as the minimum voltage required between gate and source to turn the transistor on (allow it to conduct electricity).