Search results
Results from the WOW.Com Content Network
The decibel watt (dBW or dB W) is a unit for the measurement of the strength of a signal expressed in decibels relative to one watt.It is used because of its capability to express both very large and very small values of power in a short range of number; e.g., 1 milliwatt = −30 dBW, 1 watt = 0 dBW, 10 watts = 10 dBW, 100 watts = 20 dBW, and 1,000,000 W = 60 dBW.
The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...
dBm or dB mW (decibel-milliwatts) is a unit of power level expressed using a logarithmic decibel (dB) scale respective to one milliwatt (mW). It is commonly used by radio, microwave and fiber-optical communication technicians & engineers to measure the power of system transmissions on a log scale , which can express both very large and very ...
dBc (decibels relative to the carrier) is the power ratio of a signal to a carrier signal, expressed in decibels.For example, phase noise is expressed in dBc/Hz at a given frequency offset from the carrier. dBc can also be used as a measurement of Spurious-Free Dynamic Range between the desired signal and unwanted spurious outputs resulting from the use of signal converters such as a digital ...
For very low-power systems, such as mobile phones, signal strength is usually expressed in dB-microvolts per metre (dBμV/m) or in decibels above a reference level of one milliwatt . In broadcasting terminology, 1 mV/m is 1000 μV/m or 60 dBμ (often written dBu).
Many high-quality domestic speakers have a sensitivity between ~84 dB and ~94 dB, but professional speakers can have a sensitivity between ~90 dB and ~100 dB. An '84 dB' source would require a 400-watt amplifier to produce the same acoustical power (perceived loudness) as a '90 dB' source being driven by a 100-watt amplifier, or a '100 dB ...
The noise factor (a linear term) is more often expressed as the noise figure (in decibels) using the conversion: = The noise figure can also be seen as the decrease in signal-to-noise ratio (SNR) caused by passing a signal through a system if the original signal had a noise temperature of 290 K. This is a common way of expressing the noise ...
Sound exposure level (SEL) is a logarithmic measure of the sound exposure of a sound relative to a reference value. Sound exposure level, denoted L E and measured in dB, is defined by [1]