Search results
Results from the WOW.Com Content Network
[1] [2] The procedure is commonly used at smaller airports and private strips which may not have separate paved taxiways parallel to the runway. It is a higher-risk procedure, as pilots may not see, or hear the radio transmissions from, aircraft taxiing on the runway.
Intersecting Taxiway: before the intersection with a taxiway that will have other aircraft taxiing for takeoff or parking. Point on Runway: before a designated point. This is the newest type, used when safety precautions are needed due to hazards concerning other runways or taxiways, or hazards for a landing plane on its runway (ice, for instance).
Taxiing (rarely spelled taxying) [1] is the movement of an aircraft on the ground, under its own power, in contrast to towing or pushback where the aircraft is moved by a tug. The aircraft usually moves on wheels, but the term also includes aircraft with skis or floats (for water-based travel).
Runway Holding Position Markings These show where an aircraft should stop when approaching a runway from a taxiway. They consist of four yellow lines, two solid and two dashed, spaced six or twelve inches (15 or 30 cm) apart, and extending across the width of the taxiway or runway.
Takeoff is the phase of flight in which an aircraft goes through a transition from moving along the ground to flying in the air, usually starting on a runway.For balloons, helicopters and some specialized fixed-wing aircraft (VTOL aircraft such as the Harrier), no runway is needed.
Below the decision speed, the airplane should be able to stop safely before the end of the runway. Above the decision speed, the airplane may overshoot the runway if the takeoff is aborted, and, therefore, a rejected takeoff is normally not performed above this speed, unless there is reason to doubt the airplane's ability to fly.
After the co-pilot calls V 1, they will call V R or "rotate," marking speed at which to rotate the aircraft. The V R for transport category aircraft is calculated such as to allow the aircraft to reach the regulatory screen height at V 2 with one engine failed. Then, V 2 (the safe takeoff speed) is called. This speed must be maintained after an ...
Runway confusion is when a single aircraft uses the wrong runway, or a taxiway, for takeoff or landing. [7] Runway confusions are considered a subset of runway incursions. Three major factors that increase the risk of runway confusion include airport complexity, close proximity of runway thresholds, and joint use of a runway as a taxiway. [8]