enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Allis-Chalmers D series - Wikipedia

   en.wikipedia.org/wiki/Allis-Chalmers_D_series

   These tractors featured three-point hitches, power steering and diesel engine options. Low-compression fuel options for kerosene and distillate were dropped. [1] [2] Most of the D-series tractors, except for the D21, had hand-operated, shift-on-the-go oil clutches, commonly referred to as a hand clutch. Allis-Chalmers marketed this arrangement ...

3. Power shuttle - Wikipedia

   en.wikipedia.org/wiki/Power_shuttle

   During, the pressure rise,F-R clutch is in energized condition which makes the vehicle to move forward/Reverse direction. Flow to tank line is blocked during the flow to F/R clutch. Power shuttle are incorporated in transmissions in three forms: counter-shaft , full planetary (power shifts) , and CVT transmissions .

4. Electromagnetic clutches and brakes - Wikipedia

   en.wikipedia.org/wiki/Electromagnetic_clutches...

   Based upon the size of the clutch or brake, the speed and the inertia, wear rates will differ. For example, a machine that was running at 500 rpm with a clutch and is now sped up to 1000 rpm would have its wear rate significantly increased because the amount of energy required to start the same amount of inertia is a lot higher at the higher speed.

5. Agricultural machinery - Wikipedia

   en.wikipedia.org/wiki/Agricultural_machinery

   There are many types of such equipment, from hand tools and power tools to tractors and the farm implements that they tow or operate. Machinery is used in both organic and nonorganic farming. Especially since the advent of mechanised agriculture , agricultural machinery is an indispensable part of how the world is fed.

6. Allis-Chalmers - Wikipedia

   en.wikipedia.org/wiki/Allis-Chalmers

   Allis-Chalmers was a U.S. manufacturer of machinery for various industries.Its business lines included agricultural equipment, construction equipment, power generation and power transmission equipment, and machinery for use in industrial settings such as factories, flour mills, sawmills, textile mills, steel mills, refineries, mines, and ore mills.

7. Spline (mechanical) - Wikipedia

   en.wikipedia.org/wiki/Spline_(mechanical)

   Often, with internal splines, the splined portion of the part may not have a through-hole, which precludes use of a pull / push broach or extrusion-type method. Also, if the part is small it may be difficult to fit a milling or grinding tool into the area where the splines are machined.