enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Post (structural) - Wikipedia

   en.wikipedia.org/wiki/Post_(structural)

   Principal – A primary support. Principal is a general term meaning a "major" member often distinguished from "common" or "minor" members. [9] Angle – A historical name for a corner post. Intermediate – A post in an exterior wall not at a corner. Chimney – An intermediate post receiving its name from being near a chimney.

3. Framing (construction) - Wikipedia

   en.wikipedia.org/wiki/Framing_(construction)

   Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a

4. Corbel - Wikipedia

   en.wikipedia.org/wiki/Corbel

   In architecture, a corbel is a structural piece of stone, wood or metal jutting from a wall to carry a superincumbent weight, [1] a type of bracket. [2] A corbel is a solid piece of material in the wall, whereas a console is a piece applied to the structure. A piece of timber projecting in the same way was called a "tassel" or a "bragger" in ...

5. Pole building framing - Wikipedia

   en.wikipedia.org/wiki/Pole_building_framing

   Siding materials for a pole building are most commonly rolled-rib 29-gauge enameled steel cut to length in 32-or-36-inch (813 or 914 mm) widths attached using color-matched screws with rubber washers to seal the holes. However, any standard siding can be used, including T1-11, vinyl, lap siding, cedar and even brick.

6. Girt - Wikipedia

   en.wikipedia.org/wiki/Girt

   In architecture or structural engineering, a girt, also known as a sheeting rail, is a horizontal structural member in a framed wall. Girts provide lateral support to the wall panel, primarily to resist wind loads. [citation needed] A comparable element in roof construction is a purlin.

7. Domestic roof construction - Wikipedia

   en.wikipedia.org/wiki/Domestic_roof_construction

   The blue pieces are roll formed metal roof battens or purlins. This roof is built with purpose-made steel hook bracket which is bolted to the truss with M16 bolt. The bracket is bolted to an M16 bolt cast in situ, embedded 300 mm (12 in) into the reinforced concrete block wall.

8. Bracket (architecture) - Wikipedia

   en.wikipedia.org/wiki/Bracket_(architecture)

   In adjustable shelving systems, the bracket may be in two parts, with the load-bearing horizontal support fitting into a wall-mounted slotted vertical metal strip. Brackets also are an element in the systems used to mount modern facade cladding systems onto the outside of contemporary buildings, as well as interior panels.

9. Tie (engineering) - Wikipedia

   en.wikipedia.org/wiki/Tie_(engineering)

   Hurricane ties are in place at the top of the wall as the roof trusses are being placed. A hurricane tie (also known as hurricane clip or strip) is used to help make a structure (specifically wooden structures) more resistant to high winds (such as in hurricanes), resisting uplift, racking, overturning, and sliding. [3]