enow.com Web Search

  1. Ads

    related to: pre wired led with resistor and battery

Search results

  1. Results from the WOW.Com Content Network
  2. LED circuit - Wikipedia

    en.wikipedia.org/wiki/LED_circuit

    LEDs with built-in series resistors are available. These may save printed circuit board space, and are especially useful when building prototypes or populating a PCB in a way other than its designers intended. However, the resistor value is set at the time of manufacture, removing one of the key methods of setting the LED's intensity.

  3. Holiday lighting technology - Wikipedia

    en.wikipedia.org/wiki/Holiday_lighting_technology

    Neon-lamp-based sets have lamps connected in parallel, each with its own current-limiting resistor. Battery-powered sets are also wired in parallel. [citation needed] Some incandescent or LED-based strings use a power supply transformer with lamps connected in parallel. These sets are much safer, but there is a voltage drop at the end of the ...

  4. Thermal management of high-power LEDs - Wikipedia

    en.wikipedia.org/wiki/Thermal_management_of_high...

    LED power dissipation is modeled as a current source; thermal resistance is modeled as a resistor; and the ambient temperature is modeled as a voltage source. High power light-emitting diodes (LEDs) can use 350 milliwatts or more in a single LED. Most of the electricity in an LED becomes heat rather than light (about 70% heat and 30% light). [1]

  5. Electrical ballast - Wikipedia

    en.wikipedia.org/wiki/Electrical_ballast

    Another common use of a ballast resistor in the automotive industry is adjusting the ventilation fan speed. The ballast is a fixed resistor with usually two center taps, and the fan speed selector switch is used to bypass portions of the ballast: all of them for full speed, and none for the low speed setting.

  6. Joule thief - Wikipedia

    en.wikipedia.org/wiki/Joule_thief

    The coil consists of a standard ferrite toroid core with two windings of 20 turns each using 0.15 mm (0.006 inch) diameter wire (38 swg) (34-35 AWG). The circuit can utilize an input voltage down to about 0.35 V and can run for weeks using a 1.5 V LR6/AA. The battery voltage is usually 1.5 V. The resistor is ~1 kΩ, 1/4 W.

  7. 'Boy in the Box' Was Found Slain, Severely Beaten and Nude ...

    www.aol.com/boy-box-found-slain-severely...

    Two years after finally being identified, the "Boy in the Box" case continues to haunt Philadelphia. The slain body of Joseph Augustus Zarelli, 4, was discovered in February 1957 in Philadelphia's ...

  1. Ads

    related to: pre wired led with resistor and battery