Search results
Results from the WOW.Com Content Network
It is designed to allow a shorter interval between flushes than individual cisterns. Flushing troughs were commonly used in places such as schools, colleges, public toilets, factories and public buildings where repeated use of the flushing cistern was required in a short period of time. Such troughs were used by local councils in the UK into ...
If the toilet is flushed from a tank, a large holding cistern is mounted above the toilet, containing approximately 4.5 to 6 L (1.2 to 1.6 US gallons) of water in modern designs. This tank is built with a large drain 50 to 75 mm (2 to 3 inches) diameter hole at its bottom covered by a flapper valve that allows the water to rapidly leave the ...
The modern toilet utilises a cistern to reserve and hold the correct amount of water required to flush the toilet bowl. In earlier toilets, the cistern was located high above the toilet bowl and connected to it by a long pipe. It was necessary to pull a hanging chain connected to a release valve located inside the cistern in order to flush the ...
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses ...
In many modern boats, the heads look similar to seated flush toilets but use a system of valves and pumps that brings sea water into the toilet and pumps the waste out through the hull (in place of the more normal cistern and plumbing trap) to a drain. In small boats the pump is often hand operated.
[D] The term "outhouse" is used in North American English for the structure over a toilet, usually a pit latrine ("long drop"). However, in British English "outhouse" means any outbuilding, such as a shed or barn. [citation needed] In Australia and parts of Canada an outdoor toilet is known as a "dunny". "Privy", an archaic variant of "private ...
When the handle of a flush toilet with a tank (British, cistern) is turned, a discharge mechanism is activated by means of a rod or chain. The mechanism may be a flapper valve, which is designed to sink more slowly than the water - allowing the water to exit to the toilet bowl below, so that the tank may empty.
The lack of siphoning also means that the toilet requires less water to operate. [6] Due to this, the waterline is considerably lower than that in siphon-flush toilets. The toilet has two buttons on the cistern rather than the single-flush one; one button delivers a lesser amount of water (eg. 3 litres) and the other a greater amount (eg. 6 ...