enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Multimeter - Wikipedia

   en.wikipedia.org/wiki/Multimeter

   Analog multimeter Digital multimeter. A multimeter (also known as a volt-ohm-milliammeter, volt-ohmmeter or VOM) [1] is a measuring instrument that can measure multiple electrical properties. [2] [3] A typical multimeter can measure voltage, resistance, and current, [4] in which case can be used as a voltmeter, ohmmeter, and ammeter.

3. Ohmmeter - Wikipedia

   en.wikipedia.org/wiki/Ohmmeter

   This is partly because the change in deflection itself is small when the resistance measured is too small in proportion to the intrinsic resistance of the ohmmeter (which can be dealt with through current division), but mostly because the meter's reading is the sum of the resistance of the measuring leads, the contact resistances and the ...

4. ESR meter - Wikipedia

   en.wikipedia.org/wiki/ESR_meter

   A typical ESR Meter. This one also measures capacitance. An ESR meter is a two-terminal electronic measuring instrument designed and used primarily to measure the equivalent series resistance (ESR) of real capacitors; usually without the need to disconnect the capacitor from the circuit it is connected to.

5. Electrical resistance and conductance - Wikipedia

   en.wikipedia.org/wiki/Electrical_resistance_and...

   Also called chordal or DC resistance This corresponds to the usual definition of resistance; the voltage divided by the current R s t a t i c = V I. {\displaystyle R_{\mathrm {static} }={V \over I}.} It is the slope of the line (chord) from the origin through the point on the curve. Static resistance determines the power dissipation in an electrical component. Points on the current–voltage ...

6. Electrical isolation test - Wikipedia

   en.wikipedia.org/wiki/Electrical_isolation_test

   Isolation resistance measurements may be achieved using a high input impedance ohmmeter, digital multimeter (DMM) or current-limited Hipot test instrument. The selected equipment should not over-stress sensitive electronic components comprising the subsystem.

7. Continuity test - Wikipedia

   en.wikipedia.org/wiki/Continuity_test

   In electronics, a continuity test is the checking of an electric circuit to see if current flows (that it is in fact a complete circuit). A continuity test is performed by placing a small voltage (wired in series with an LED or noise-producing component such as a piezoelectric speaker) across the chosen path.

8. Megohmmeter - Wikipedia

   en.wikipedia.org/wiki/Megohmmeter

   Megohmmeter M1101M. A Megohmmeter or insulation resistance tester, is a special type of ohmmeter used to measure the electrical resistance of insulators. [1] Insulating components, for example cable jackets, must be tested for their insulation strength at the time of commissioning and as part of maintenance of high voltage electrical equipment and installations.

9. Ohm - Wikipedia

   en.wikipedia.org/wiki/Ohm

   One of the functions of many types of multimeters is the measurement of resistance in ohms.. The ohm is defined as an electrical resistance between two points of a conductor when a constant potential difference of one volt (V), applied to these points, produces in the conductor a current of one ampere (A), the conductor not being the seat of any electromotive force.